 |
 |
 |
|
This is a 110/220VAC wall adapter 5 Volt passthrough for the GG Telescopic Storm - it is NOT compatible with the GG Transformer. This will only operate at 5V and 2000mAh.
Included in the kit is:
1 x 5V 2000mAh wall transformer (with euro adapter), 4 foot cord and GGTS connector (not shown in photo)
1 x False "battery" which takes place of batteries inside the GGTS and passes power to the atomizer (black part in photo)
1 x Replacement end cap to connect the wall adapter to. (silver/gold part in photo)
To use the wall adapter follow these steps:
DO NOT PLUG THE WALL ADAPTER IN UNTIL THAT STEP IS REACHED!
Unscrew top cap and remove all batteries
Unscrew and remove bottom cap from GGTS
Attach wall adapter bottom cap to wall adapter cord and snug connections firmly - hold onto the brass center connection while screwing onto the wall adapter connection
Telescope the GGTS "out" by unscrewing counterclockwise until almost fully extended
Insert the false "battery" into the GGTS (orientation is not important)
Screw top cap with atomizer already installed onto top (farthest from button) of the GGTS
Screw bottom cap with wall adapter cord attached onto bottom (nearest button) of the GGTS
Plug the wall adapter into a 110/200V wall socket
Telescope the GGTS "in" by screwing clockwise while periodically pressing the button and listening for the atomizer to sizzle - careful not to over tighten!
Once you hear the atomizer sizzle turn approximately 1/8th more - you may need to adjust during use
Use as normal. Remember you are now tethered to a cord so don't pull your GGTS further than the cord will allow
To return to batteries just reverse the steps above
If the GGTS wall adapter is constantly in the ON state then disassemble and repeat. You may have overtightened the components or the center post of the wall adapter bottom cap is not tight
MADE IN GREECE |
|
|
|
|
|
|
|
|
