PLEASE NOTE: We are transitioning to long wicks. You may receive short or long wicks depending on our stock. This is unfortunately not a choice. The long wicks have shown to wick better.
These are the new transparent clearomizers for the eGo/eGo-T/eGo-C batteries. They are the standard resistance version and are around 2.5 to 2.9 Ohms resistance and are ideal for regular eGo style batteries or other batteries/mods.
These are the V2 Vision with SHORT wicks. The short wicks work just the same as the "long" wicks you may have read about except they need turned upside down or laid sideways occasionally to keep the wicks wet. The V2 also have improved tubes and a slight improvement to the wick material/coil. At this time we see no reason to carry both short and long wick versions.
These have round mouthpieces. Flat mouthpiece versions are available as well.
Because the tubes are polycarbonate plastic, they may degrade or crack with some liquids such as cinnamon or pineapple. This is not covered by warranty.
The clear liquid reservoir allows you to monitor the fill level. They will hold about 1.6ml of liquid.
No filler material!
The mouthpiece has a silicone seal and when screwed into the clearomizer tank keeps the liquid from being able to leak out.
When you first fill these you want to drip the liquid to the inside of the tank. Do not put the liquid in the center hole or you'll fill your hand up with liquid. :)
Once full, allow it to sit for about 2 minutes. This will give the feeding wicks time to bring liquid up into the coil.
Since the feeding wicks are up high in the tank, these will work fine if inverted. As the liquid level gets lower, you'll want to set it sideways once in a while to let the feeding wicks get wet again.
These are compatible with the eGo/eGo-T/eGo-C batteries. They may also work with other eGo clones but there is no guarantee.
This item is for (1) Vision standard resistance eGo clearomizer. eGo-T battery and extra Vision eGo clearomizer shown in photo is -not- included.